How to repair a window?

Windows that are broken or cracked could potentially cause a lot of trouble. They could even require expensive repairing which could only be done by a local glazier Melbourne or from a glass repairs and replacement Melbourne which is quite expensive and could burn a hole in your wallet.

No matter what people say, you could actually repair the window on your own and it is definitely inexpensive and will save you a lot of money. Why hire someone to do a job which you could do on your own. You just need to get some tools and materials, some you might already have with you.

Procedure: For Older & Unsealed Glass Windows that are Single-Pane

If you are looking to repair your windows that have been there for a long time such as since it was built in the 60s or even in the 50s then chances of the windows being updated are low and you would need to update the, However, if you have a triple or even a double-pane window (usually referred to as insulated or thermal windows) in which case you would need to hire a professional to get the windows replaced.

Things that you need:
– Safety Glasses
– Thick Leather Work Gloves
– Putty Knife
– Fine-Grit Sandpaper
– Razor Scraper or Wood Chisel
– Paintbrush
– Clear Wood Sealer or Linseed Oil
– Measuring Tape
– Glass Cutter
– Pencil
– Glazing Compound
– Glazier Points

Fix a Broken Window

Step 1: Firstly, you need to understand how the window pane is actually fastened into the frame. It is done by placing the visible glazing compound under the glazier points. The tiny nails under it hold the window.
You will need to use a putty knife and pry up the glazing compound with it. It should easily come off in big chunks. Now, just use the putty knife to remove the glazier points. One should always wear thick gloves when doing this. Leather gloves are recommended when removing all the glass that has been broken.

See also  Myotherapy Is An Effective Treatment To Relieve Pain

Step 2: Now, you need to use a razor scraper or chisel to help scrape down the sections of the frame. Do not gouge the wood. Next, you need to use the fine-grit sandpaper to sand the wood smooth and then seal any of the bare wood with the linseed oil.

Step 3: It is time to measure and cut the size of the new glass window. You could have it done at the hardware store or by yourself with just a simple glass cutter which is easy to use. Measure the width and the height of the opening of the window with the measuring tape. In order to cut the glass on your own, you need to place it on flat and clean work surface. Wear safety glass when cutting the glass.

Step 4: Finally, place the glass which you have cut into the L-shaped holder with great care so that the nails remain intact. Follow these 4 steps to repair your glass window on your own or contact Smith Glass.

Leave a Reply